Administrator's Guide

Settings/Maintenance
39
F
The following screen is displayed after printing
the first sheet. Follow the on-screen
instructions, and then click OK.
The charts the second sheet and after are
printed.
G
Wait for 30 minutes until drying is complete.
Make sure the printed correction charts do not
overlap during the drying process.
Check the the drying time displayed on Status.
When the drying time reaches 0, Drying
complete. is displayed, and the Measure Color
button becomes available.
When the printed chart is dry, perform color
measurement.
Operations may differ depending on the color
measurement device you use.
U “Correction chart color measurement (for
the "i1Pro")” on page 40
U “Correction chart color measurement (for
the "i1iSis")” on page 42
Note:
Do not allow the printed correction charts to
overlap while drying. The color tone of the
overlapped section may differ, leading to
improper calibration.
Tip:
If the confirmation message is set not to display
in Completion Confirmation for Long Length
Sheet Printing from Printer Operation Settings,
this message is not displayed.
U “Printer Operation Settings” on page 23