Specifications

EPSON 5–15
SED1225 Series
SED1225
Series
(4) Horizontal vertical flipping
. . . . .
. . .
COM1
COM16 (N=1)
COM24 (N=0)
SEG1 SEG60
(6) RAM Address Setup
The RAM Address Setup command sets an address
into the Address counter to write data into
DDRAM, CGRAM and Symbol register.
When the cursor display is ON, the cursor is
located at a position corresponding to the DDRAM
address set by this command.
1 The 00H to 7FH address length can be set.
To write data in the RAM, set the data write
address by this command. When the
subsequent data is written continuously, the
address is automatically incremented.
A0 XWR D7 D0
0 0 1 ADDRESS
✽ : Don’t Care
0
CGRAM (00H)
SI1 SI2 EV
TEST LED
For signals
Unused Unused
Unused
Unused
Unused
Unused
Unused
DDRAM line 1
DDRAM line 2
DDRAM line 3
Symbol register
Symbol register
CGRAM (01H)
CGRAM (02H) CGRAM (03H)
123456789ABCDEF
00H
10H
20H
30H
40H
50H
60H
70H
SI
EV
TEST
LED
For signals
Symbol register
: LED register
: SEGS1, 2, 4, 5
: COMS1, COMS2
: Static Icon register
: Electronic Control register
: Test register
(Do not use in normal operations.)
RAM map
(7) Data Write
1 This command writes data in the DDRAM,
CGRAM or Symbol register.
2 When this command is executed, the Address
counter is incremented by 1 automatically.
This allows continuous data writing.
Write data
NO
YES
Single line
completed?
Set the RAM address
Note: Assign an enough time greater than "tcyc"
before executing the next instruction.
A0 XWR D7 D0
1 0 DATA
✽ : Don’t Care
Data write example:
The following gives an example to write a
single line of data continuously.