Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ R R4C475Setup Guide Rev_C A5 size 2/15/00 Printing Your First Page SETUP.
L R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ Attaching the Paper Support Insert the paper support into the slots at the rear of the printer. Plugging in the Printer 1. Make sure that the printer is turned off. It is off when the P power button protrudes slightly from the surface of the control panel. 2.
Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Connecting the Printer If you have a PC, it is possible to connect to your printer via the parallel or USB interface. Macintosh can only be connected via the USB interface. Depending upon your geographic location, you may have to acquire the appropriate cable. See "Options and Consumable Products" in the Daily Use guide for details.
L R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ 2. Plug the appropriate end of the cable into the USB port on the back of the printer. (The end that fits the printer has a different shape from the end that fits the computer.) 3. Connect the other end of the cable to the computer’s USB port.
Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Installing in Windows Follow these steps to install your printer software. 1. Make sure that your printer is off. 2. 3. 4. 5. 6. Turn on your computer and start Windows. If the New Hardware Found screen or any other Wizard appears, click Cancel. Insert the printer software CD shipped with your printer in the CDROM drive. The Installer dialog box appears.
L R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ Note: If the Setup utility does not start, go to step the printer’s control panel. 7. to install the ink cartridge using When a message appears informing you that the installation is complete, click OK. Note: If an error message appears, either the printer driver or the EPSON USB printer device driver is not installed correctly. See "Troubleshooting" in the Daily Use guide.
Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Installing in Macintosh c Caution: Turn off all virus protection programs before you install your printer software. Follow these steps to install your printer software. 1. Turn on your Macintosh and insert the software CD in the CD-ROM drive. The EPSON printer software disk opens automatically. 2. 3. 4. 5. If a single Installer icon appears, double-click the icon.
L R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ 1. Choose Chooser from the Apple menu. Then click your printer's icon and the port your printer is connected to. 2. Select the appropriate Background Printing radio button to turn background printing on or off. When background printing is on, you can use your Macintosh while it is preparing a document for printing.
Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Using the printer’s control panel for PCs and Macintosh If you are a Macintosh user, or are unable to access the Setup utility, use the printer’s control panel to install the ink cartridges. Note: Do not open the ink cartridge packages until just before you install them. If you leave a cartidge unpacked for a long time before using it, normal printing may not be possible.
L R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ 3. Push back the release tabs and lift up the ink cartridge clamps. 4. Open the ink cartridge packages. Next, remove only the yellow tape seals from each cartridge. c Caution: ❏ You must remove the yellow tape seals from the cartridges before installing them; otherwise, the cartridges will become unusable and you will be unable to print.
Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ 5. R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Align the tabs on each ink cartridge so that they are resting on the tabs protruding from the base of the opened ink cartridge clamps. Do not apply excessive force to the cartridges. c Caution: Make sure the ink cartridge tabs are not under the tabs protruding from the base of the opened ink cartridge clamps, as this could damage the clamps. Note: Install both ink cartridges.
L R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 c Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ Caution: Always press the orange ink replacement button to move the print head. Do not move the print head by hand. Doing so may damage the printer. While the ink is charging, the P power light flashes and the printer produces a variety of mechanical sounds. These sounds are normal.
Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ 2. 3. R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Fan a stack of paper, then tap it on a flat surface to even the edges. Load the stack of paper with the printable side up and the right edge of the paper resting against the right side of the sheet feeder. Then slide the left edge guide against the left edge of the paper. printable side up Note: ❏ Always load paper into the sheet feeder short edge first.
L R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ Cleaning the print head Follow the steps below to clean the print head. 1. Make sure that the P power light is on and that both the B black and A color ink out lights are off. 2. Hold down the T cleaning button for three seconds. The printer starts cleaning the print head and the P power light begins flashing. Print head cleaning takes about thirty seconds to complete.
Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 For Windows Follow these steps to print the sample file. 1. Make sure A4 or Letter size EPSON Photo Quality Ink Jet Paper is loaded in the printer. 2. Insert the printer driver CD-ROM. If the Installer dialog box appears, click Quit. 3. Double-click the My Computer icon and then the CD-ROM icon. Then double-click the sample.bmp file to open it. 4.
L R4C475Setup Guide Rev_C A5 size 2/15/00 SETUP.FM Pass 0 Proof Sign-off: M.Hida, CRE Tsukada_______ N.Nomoto _______ _______ 10. Click OK at the bottom of the driver. You return to the Print dialog box (or a similar dialog box). 11. Click Close, OK, or Print to print. You may need to click a combination of these buttons. While printing, the EPSON Progress Meter will appear, showing the printing progress and the status of your printer. For Macintosh Follow these steps to print the sample file. 1.
