User manual
X K 3 1 9 0C 602
Chapter 5 Operating Instruction of Quantitative Scale
I. Startup and zero setting upon startup
1. After power is connected, the screen will full display for 10 seconds and show the indicator
type and software version, then finally enter the weighing status. If the buttonExitis pressed
halfway, then automatic checking will be ended in advance.
2. If the setting of ‘zero setting upon startup’ is valid, the empty scale weight deviates from zero
and is still in zero setting scope after startup, the screen will perform zero setting upon startup
automatically; If it is not in the zero setting scope, the screen will show the weight based on zero
point upon shutting down. Please see the setting of parameter C in parameter 2 of Chapter
Parameter Setting for zero setting scope upon startup.
3. If the ‘zero setting upon startup’ switch is set OFF, the screen will show the weight after
startup based on zero point upon shutting down. The operation ofZero settingbutton for the first
time will be regarded as the initial zero setting.
II. Manual Zero Setting
If the display value deviates from zero and is still in the manual zero setting scope while the
light is stable ON, pressZero settingbutton to get the display value back to zero and zero point
lamp will be ON. Please see the setting of parameter B in parameter 2 of Chapter [SET
1] of parameter setting for manual zero setting scope.
If it is in net weight status now, press Zero settingbutton to change to gross weight
display status and press buttonZero settingagain to perform zero setting operation.
III. Tare
Under the weighing status, when the display weight is positive and is stable, press button
[Tare] to deduct the display weight, which serves as the tare weight. Then the current display net
weight will be 0 and the display light for net weight will be ON.
The following operations are mentioned in the chapter of parameter setting, it will be
described repeatedly in push-button order, which can help to memorize it.
IV. Setting of Date and Time
Setting8Inputdate setting8Inputtime setting8Input
[ ABCD]
[0 SEt ]
[ ABCD]
[
0
S
E
t
]