Operator`s manual

2-5
2. Cleaning floppy disk drives
The heads in the floppy disk drive of the terminal unit and Inmarsat-C should be
cleaned regularly to prevent damage to floppy disks. Use a cleaning floppy disk.
(FURUNO can supply a cleaning floppy disk. It is type MCD-2, code no. 000-116-420.)
Procedure
1. Insert ∞a cleaning floppy disk in the drive.
2. Execute “Format” operation (in the F1 menu). The access lamp on the drive lights.
3. Wait until the access lamp goes off. Remove the disk. (Error message for formatting
appears on the screen.)
2.3 Printer PP-510
Turning on the power
Turn on the POWER switch at the front of the printer. The POWER and ON LINE lamps
light. The printer is now ready to print. If the ON LINE lamp is off, press the ON LINE switch
to turn it on; No print is done when the ON LINE lamp is off.
P.PARK
FF
LF
NLQ
ON LINE
POWER Lamp
P.OUT Lamp
Lights when paper
put or internal error
is found.
These keys are operative when the
printers is in off line state
(ON LINE lamp is off).
POWER
switch
Toggles between online and
offline state.
Key description
[NLQ] (Near Letter Quality) key
Toggles between draft and NLQ print modes. Lighting the key selects near letter quality
(high quality) print.
[LF] key
Advances the paper one line. Press and hold down the key to advance the paper
continuously.
[FF] key
Advances the paper to the top of the next available form. The default form length is 11
inches.
[P.PARK] key
Backs the paper by maximum 18 inches. If the paper is not detected after backing it, the
P. OUT lamp blinks three times and the printer stays in offline state.