Specifications

ManualsBrandsErgotron Manualselectrical equipment & suppliesDM10-1007-1

1 of 13

< 24lbs. (11 kg)

Reduce.Reuse.Recycle

Tablet Management Wall Mount 10

for iPad®

ENGLISH

888-61-092-G-00 rev. A • 12/13

CAUTION: DO NOT EXCEED MAXIMUM LISTED

WEIGHT CAPACITY. SERIOUS INJURY OR

PROPERTY DAMAGE MAY OCCUR!

Table of Contents

Hazard Symbols Review & Safety ................................................2

Components & Tools ...................................................................2

Mounting Considerations ............................................................3

Set-up ....................................................................................3 - 8

Wood Stud Attachment ...........................................................4

Concrete Attachment ...............................................................6

Charging and Syncing ........................................................10 - 11

Cleaning and Maintenance........................................................12

Speci cations ............................................................................13

Service and Warranty Information ............................................13

Apple, iPad, iPad Air, iPad mini, Retina, iTunes, Lightning and Macintosh are trademarks of Apple Inc., registered in the U.S. and other countries.

“Made for iPad” means that an electronic accessory has been designed to connect speci cally to iPad, and has been certi ed by the developer to meet Apple

performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the

use of this accessory with iPad may a ect wireless.

Summary of content (13 pages)

PAGE 1
for iPad® Table of Contents Hazard Symbols Review & Safety ................................................2 Components & Tools ...................................................................2 Mounting Considerations ............................................................3 Set-up ....................................................................................3 - 8 Wood Stud Attachment ...........................................................4 Concrete Attachment..............................
PAGE 2
ENGLISH Hazard Symbols Review Symbol These symbols alert users of a safety condition that demands attention. All users should be able to recognize and understand the significance of the following Safety Hazards if encountered on the product or within the documentation.
PAGE 3
ENGLISH 1 Mounting Considerations Space Requirements: 24" (610 mm) Minimum space needed when removing front cover (for service access only). If 24” (610 mm) is not available, unit can be removed from the wall for service, if needed. When mounting to wood stud, at least one screw in the upper mounting bracket must be installed in a stud (preferably the center hole). 43.2" (1098 mm) 5.7" 10" (254 mm) (145 mm) 11.8" 4" 5.
PAGE 4
ENGLISH 2 WOOD AND HOLLOW WALL a b 60”-66" (1524-1676 mm) c NOTE: The stud can be located at one of five mounting holes on the top bracket. While the first option (center hole of bracket) is recommended for most cases, you should consult with a construction professional to confirm which method is best suited for your particular situation. Options 2-5 are illustrated on the following page in no order of preference. Hole Option 1 RECOMMENDED Center Hole in Stud 888-61-092-G-00 rev.
PAGE 5
ENGLISH STUD LOCATION OPTIONS 2-5 Hole Option 2 Hole Option 3 Hole Option 4 Extreme Left Hole in Stud Extreme Right Hole in Stud Middle Right Hole in Stud Hole Option 5 Middle Left Hole in Stud d 60”-66" (1524-1676 mm) 6 888-61-092-G-00 rev.
PAGE 6
ENGLISH WOOD AND HOLLOW WALL the three holes in the top bracket that correspond with the hole option determined e Drill on previous page. Then drill the two holes in the bottom bracket. NOTE: Use the Ø 3/16” (5 mm) drill bit when drilling directly into the wood stud.Use the Ø 1/2” (13 mm) drill bit when drilling into the hollow wall for the anchors. Use hollow wall anchors where ever a screw does not get inserted directly into the wood stud.
PAGE 7
ENGLISH CONCRETE a b 60”-66" (1524-1676 mm) 60”-66" (1524-1676 mm) c d Ø 3/8" (10 mm) 3-1/8" (80 mm) WARNING: Mounting holes must be at least 3-1/8” (80mm) deep and must be located within solid concrete, not mortar or covering material.
PAGE 8
ENGLISH 3 4 2x M4 x 8mm PENTA 5 6 a NOTE: You can push up to 3 feet (1 m) of excess power cord up into the unit for storage. Place wrench in Cable Restraint and run power cable through as shown. 2x b M4 x 8mm 1x 888-61-092-G-00 rev.
PAGE 9
ENGLISH 7 NOTE: To keep door unlocked, pull key out while unlocked. NOTE: Tablet screen should face the wall when inserting. 8 30 Pin Cable Lightning™ Cable 9 888-61-092-G-00 rev.
PAGE 10
ENGLISH 10 Tablet Charging To begin charging the tablets, plug in the power cord. The power cord is used to turn the power on and off. Charging occurs whenever the power cord is connected UNLESS a Macintosh® or PC notebook USB cable is connected for syncing. NOTE: The power cord acts as the connect/disconnect device switching power off and on. The socket outlet shall be installed near the equipment and shall be easily accessible.
PAGE 11
ENGLISH Tablet Syncing NOTE: Complete the Tablet Charging instructions before syncing. iPad devices should be charged at least 50% before starting the syncing process. Syncing can be done using iTunes® or the Apple Configurator program available for the Macintosh® computer. Please reference www.Apple.com for more information. NOTE: The devices will not charge while syncing is in process. To return to charge mode, unplug the USB cable from the TM Wall Mount 10 USB port when syncing is complete.
PAGE 12
ENGLISH Cleaning and Maintenance Equipment Electric Safety There are specific risks associated with the use of equipment having power cables. You must be aware of, and avoid these risks when this product is located in close proximity to children. WARNING: Failure to observe the following Electrical Safety notices can result in fire or death by electric shock. Electrical cables can be hazardous. Misuse can result in fire or death by electrical shock.
PAGE 13
ENGLISH Specifications Dimensions 23.2”W x 31.8”H x 4.0”D (59 x 80.9 x 10.2 cm) Power system Input: 100-240V~, 2.0A, 50/60 Hz Weight (w/o equipment) 34.5 lbs (15.