Manual

Min
6.7 [170]
Max
9.13 [232]
.25 6
Figure 2
Turn handle until
firmly against box
handle
Varies
Based on rail
or application
6.75 [170] Min
8.75 [222] Max
Rail neutral axis
Figure 1
cable C/L
Note: Dimensions are Inch [mm]
C Handle
1) Clean and prepare the contact surface of the bond area.
2) Adjust welder so that the mold is seated against the rail contour with no excessive gaps.
If mold does not seat, rub back and forth until proper seating is attained.
See Figure 1
Prior to making a connection, read and follow the full instruction sheet:
IPRSW shipped with ERICO CADWELD mold and special instructions below.
3) Install C-handle as shown in Figure 1.
Position into the horizontal position as shown in Figure 2.
Rotate Handle to come in contact with the box wall.
Adjust welder so that the mold is held firmly against the rail as shown.
TECHNICAL SUPPORT
www.erico.com
IP8290_A 1 OF 1
INSTRUCTION SHEET
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at 1.
www.erico.com and from your ERICO customer service representative.
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property 4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
ERICO® CADWELD®
Rail Box Clamp # C123
© 2014 ERICO International Corporation.