INSTRUCTION SHEET CSBSTU Longitudinal Standard Universal Sway Brace or Restraint Device Sway Brace Fitting Lateral *(XX) = Finish Specifier Sway Brace assemblies are intended to be installed in accordance with NFPA®-13 and the manufacturer's installation instructions. The required type, number, and size of fasteners used for the structure attachment fitting shall be in accordance with NFPA-13. Installation Angle from Vertical * All Brace and Service Pipes shown, not included WARNING: 1.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting UL® Loads (Listed for Restraints) - Lateral** Part Number Dyna-Flow® Service Pipe Sch 10 Service Pipe Sch 40 Service Pipe CSBSTU0100(XX) N/A 655 lb (2,914 N) 655 lb (2,914 N) CSBSTU0125(XX) 655 lb (2,914 N) 655 lb (2,914 N) 655 lb (2,914 N) CSBSTU0150(XX) 655 lb (2,914 N) 655 lb (2,914 N) 655 lb (2,914 N) UL Loads (Listed for Sway Braces) Lateral* Part Number Longitudinal** Dyna-Flow® EZ FLOW™
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting Notes: A) FM approved when used with 1", 1-1/4" or 2" (DN25, DN32, DN40, DN50) NPS Schedule 40, GB/T 3091, EN 10255 (Heavy), AS 1074 (Heavy) or JIS G3454 brace pipe. B) Load ratings for Schedule 40 above may also be applied to AS 1074 (Heavy), GB/T 3091, EN 10255 (Heavy) and JIS G3454 pipe.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting #1 #2 Position stamped components around service pipe #3 #4 Tighten top and bottom nuts to proper torque, reference torque chart. *(XX) Finish Specifier Finger tighten nuts and rotate assembly to desired orientation Insert brace into clamp as far as possible. Tighten set screw until head snaps off CSBSTU is a Sway Brace Fitting.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 5 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 6 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 7 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 8 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 9 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 10 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 11 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting The CSBBARJ can be installed as shown on the top flange of an I-Beam with tapered or non-tapered flanges. The CSBBARJ can be installed as shown on the top flange of an I-Beam with tapered or non-tapered flanges. CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 13 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 14 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. Concrete anchor could be cast in place, wedge, pre-set or a concrete anchor screw. CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 15 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting Through bolt shown. A lag screw may also be used. Through bolt shown. A lag screw may also be used. CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 16 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.
INSTRUCTION SHEET CSBSTU Standard Universal Sway Brace or Restraint Device Sway Brace Fitting Through bolt shown. A lag screw may also be used. Through bolt shown. A lag screw may also be used. CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation. TECHNICAL SUPPORT: www.erico.com CFS403_J 17 OF 17 © 2009, 2011, 2012, 2013, 2014 ERICO International Corporation.