Owner's manual

ManualsBrandsERICO ManualsAccessories for electricalIP6821 Cable to Lug Horizontal Splice

Prior to making a connection, read and follow the full instruction sheets IPP, IPX,

IPRNS (included only with molds used on rail property not to rail) and the special

instructions below.

Position mold on cables and lug with lug notch facing down (As shown above).

Gap lug and cables directly under tap holes.

When sleeves are used, insert sleeve on cable. Let cable end protrude .13” [3

mm] beyond end of sleeve. Position sleeve and cable into mold with flare of

sleeve against counter-bore wall. Use ERICO packing material to fill openings in

cable.

When using special frames, lock top sections of mold together. Then lock top

and bottom sections together.

Gap as Noted

TECHNICAL SUPPORT:

www.erico.com

IP6821_D

INSTRUCTION SHEET

1 OF 1

ERICO International Corporation





WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

www.erico.com

and from your ERICO customer service representative.

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

All instructions must be

completely

followed to ensure proper and safe installation and performance.

Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

Summary of content (1 pages)

PAGE 1
INSTRUCTION SHEET   Gap as Noted Prior to making a connection, read and follow the full instruction sheets IPP, IPX, IPRNS (included only with molds used on rail property not to rail) and the special instructions below. 1. Position mold on cables and lug with lug notch facing down (As shown above). Gap lug and cables directly under tap holes. 2. When sleeves are used, insert sleeve on cable. Let cable end protrude .13” [3 mm] beyond end of sleeve.