Manual

ManualsBrandsERICO ManualsAccessories for electricalIP6912 Type QT

Prior to making a connection, read and follow the full instruction sheet IPRF, the full instruction

sheet shipped with ERICO CADWELD (IPX) and special instructions below.

Clamp bottom of mold to rail.

Position cables in mold bottom with .25” [6 mm] gap between cable end and rail lip.

Reference mark cable at edge of mold for later use in checking position.

Lock halves of mold top together using toggle handles. Place on mold bottom. Lock top

and bottom sections together using toggles.

Pack all openings between mold and rail (at sides of mold) with ERICO packing material to

prevent leakage of molten welding material.

Check cable position before initiating weld reaction.

After the reaction, allow 30 seconds for the weld metal and slag to solidify.

Remove all ERICO packing material as soon as possible (may be reused).

Unlatch toggle clamps and remove mold top.

Unlatch vise grips and remove mold bottom from rail.

Note:

Care should be exercised to prevent chipping of the graphite parts.

Mold

Cables

.25" [6mm] Gap

150 lb.

[68.1 kg.]

Beth Rail

When using adaptor sleeves, let conductor

protrude 1/8" beyond end of sleeve.

.13" [3mm]

Flared Cable sleeve

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT:

www.erico.com

IP6912_B

INSTRUCTION SHEET

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

1 OF 1

ERICO International Corporation

WARNING:

1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

www.erico.com

and from your ERICO customer service representative.

2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

3. All instructions must be

completely

followed to ensure proper and safe installation and performance.

4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

damage, serious bodily injury and death.



Summary of content (1 pages)

PAGE 1
INSTRUCTION SHEET  Mold 150 lb. [68.1 kg.] Beth Rail Cables .25" [6mm] Gap .13" [3mm] Flared Cable sleeve When using adaptor sleeves, let conductor protrude 1/8" beyond end of sleeve. Prior to making a connection, read and follow the full instruction sheet IPRF, the full instruction sheet shipped with ERICO ® CADWELD ® (IPX) and special instructions below. 1. Clamp bottom of mold to rail. 2. Position cables in mold bottom with .25” [6 mm] gap between cable end and rail lip.