Owner manual

ManualsBrandsERICO ManualsAccessories for electricalIP6937 Cable to Lug Horizontal Splice

Prior to making a connection, read and follow the full instruction sheet IPRNS, the full

Instruction sheet IPP, the full instruction sheet shipped with CADWELD (IPX), and

special instructions below.

Position mold on cables and lug with lug notch facing down (As shown above). 1.

Gap lug and cables directly under tap holes as noted on mold tag.

Lock top sections of mold together. Then lock top and bottom sections together

. 2.

Gap as Noted

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT:

www.erico.com

IP6937_D

INSTRUCTION SHEET

SAFETY INSTRUCTIONS:

All governing codes and regulations and those required by the job site must be observed.

Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

1 OF 1

ERICO International Corporation

WARNING:

1. ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

www.erico.com and from your ERICO customer service representative.

2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

3. All instructions must be completely followed to ensure proper and safe installation and performance.

4. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

damage, serious bodily injury and death.

Cable to Lug

Horizontal Splice

Summary of content (1 pages)

PAGE 1
INSTRUCTION SHEET Cable to Lug Horizontal Splice Gap as Noted Prior to making a connection, read and follow the full instruction sheet IPRNS, the full Instruction sheet IPP, the full instruction sheet shipped with CADWELD® (IPX), and special instructions below. 1. Position mold on cables and lug with lug notch facing down (As shown above). Gap lug and cables directly under tap holes as noted on mold tag. 2. Lock top sections of mold together. Then lock top and bottom sections together. WARNING: 1.