User guide

Technical Specification
Table B.5 ASI Transport Stream Output (4 off)
Item Specification
Safety status SELV
Connector designations
ASI OUT 1
ASI OUT 2
ASI OUT 3
ASI OUT 4
Connector type BNC
Connector Impedance
75 Ω
Data coding 8B/10B
Channel rate 270 MBaud
Supported Packet size 188/204 bytes per transport stream packet
Burst mode Byte and single packet burst mode supported
Specification EN 50083-9:2002 Annex B
2
B.3 Control and Monitoring
B.3.1 Control Interfaces
All IP input and output configuration is performed via nCompass Control.
Table B.6 Control Interface Specification
Item Specification
Safety status SELV
Connector
The physical interface is an RJ-45 socket. There are two
control interfaces for redundancy purposes.
Format
10/100 Mbps full / half duplex auto sensing. Ethernet
control interfaces support IPv4.
Addresses
Each Ethernet interface has a unique MAC address. The
design allows the use of a floating IP address that can
move between the two control ports.
B.3.2 RELAY Connector
The relays indicate alarm and failure during initial booting. This includes the start-up
time, and time to execute self tests. After initial booting, the relays indicate the
current status of the Multiplexer. The relays indicate alarm and fail when no power is
applied to the Multiplexer.
2
Byte mode only
2/1553-FGC 101 1014 Uen B
B-7