User guide

Conditional Access
D.4 Configuring nCompass Control Equipment Setup
D.4.1 Configure CA Types
If you are scrambling using only one type of CA, then CA types do not have to be
edited.
However, if you are scrambling using more than one type of CA, then CA types must
be edited to reflect this.
Figure D.3: Configure CA Types
Configuring nCC Equipment
Setup (CA Types )
More than
one type
of CA?
Table D.1 Configure CA Types
Step Action Comments
1
In the nCompass Control Equipment Setup screen, select
Edit and then Global Settings to edit the CA Types
There is only one CA type
defined by default as
Any.
2
Delete the default Any and add in all the CA types that are
needed.
An example is shown in
Figure D.4.
A
ccess the CA Types dialog box.
See Figure D.4/Table D.1
Section D.4.1
.
Configure CA Types
Section D.4.2
Setup an ECM Generator
Define an ECMG in nCC Equipt Setup
See Table D
. 2
Section D.4.3
Setup an EMM Generator
Define an EMMG in nCC Equipt Setup
See Table D
. 3
END
No
Yes
CA types do not have to
be edited
Section D.6.3
Connecting the ECMG
and EMMG
Connect the EMMG, EMMG and the Mux
Table D
. 6
See
2/1553-FGC 101 1014 Uen B
D-5