User guide

Conditional Access
D.4.2.4 DVB Simulcrypt ECM Generator Dialog Box: ECM Generator Tab
Table D.2 Set Up an ECM Generator (continued)
Step Action Result Comments
Enter the IP address
of the ECMG
Enter the CA System
ID
Enter the required CA
Subsystem ID
The CA vendor
supplies this
information
Each vendor can allocate a CA Subsystem ID
in the range 00-FF. It is a two byte
hexadecimal number. This is to differentiate
between systems supplied by the same
vendor.
If the CASID is not on the drop-down list in the
GUI, type it in.
5
Enter the max no. of
ECM streams that
this ECMG will
require.
The maximum number of ECM streams to be
used may be unknown at this time. This
should be set to a reasonably high number
(e.g. 256) so more ECM streams can be
added at a later date. If the maximum number
of ECM streams is set too low, nCC server will
report that it is unable to route the CA.
D.4.2.5 DVB Simulcrypt ECM Generator Dialog Box: CA Types Tab
Table D.2 Set Up an ECM Generator (continued)
Step Action Result Comments
6
Click the CA Types
tab and select the
required CA Type
The CA Types setting
enables nCompass to
map services to
specific ECM
generator
In most cases the CA type Any is used. If
more than one type of CA scrambling is used,
the list on the right should show the CA types
defined earlier in Section D.4.1
7 Click OK
The configured ECM
Generator is added to
the physical map
2/1553-FGC 101 1014 Uen B
D-8