User guide

Conditional Access
D.6 ECMG Settings
D.6.1 Editing the ECMG Settings
The ECMG settings are configured in a separate table. Double click on “ECMGs” to
bring up that table.
Figure D.9 Editing ECMG Table
The MX8400 supports up to eight separate ECMG connections. Defining the ECMG
connection requires the superCASID, the IP address of the ECMG, and the port the
ECMG will use to send the ECMs to the mux. This information is supplied by the CA
vendor.
Table D.5 Editing ECMG Table
Step Action Result Comments
1 Define the ECMG number
Do not
change
Should go from 0 to 7
2 Define the SuperCASID
This is the CASID + Subsystem ID. For
example, if you have a CASID of 0x1800 and
a subsystem ID of 0x0001, then your
SuperCASID is 0x18000001. Enter it in HEX
If there is a redundant ECMG, fill in both. 3
Enter the IP Address 1 and
IP Address 2
They are the
IP addresses
of the
ECMGs.
If there is only one ECMG, only fill in IP
Address 1 and set IP Address 2 to be 0.0.0.0.
2/1553-FGC 101 1014 Uen B
D-17