User guide

Conditional Access
Figure D.14 ECM Dialog Box [Access Criteria Tab]
D.7.2 Entitlement Management Messages
D.7.2.1 EMM Dialog Box: General Tab
Table D.8 describes the procedure for adding EMMs.
Table D.8 Adding EMMs
Step Action Result Comments
1
In nCompass Control,
Equipment Setup, select the
required Physical Map.
2
Right click the transport stream
and select Add EMM
This displays a dialog box similar to that
shown in Figure D.15
3
Select the General tab and enter a
label and a user-defined PID for
the EMM.
4
From the CA System ID list, click
the required CASID
5
From the CA Type list, click the
required CA type
If more than one type of CA is used, the list
shows the CA types defined earlier
6
Ensure Disable CA Descriptor in
CAT check box is NOT selected
If the check box selected, the CA descriptor
will not appear in the outgoing CAT
2/1553-FGC 101 1014 Uen B
D-24