User guide

Conditional Access
Figure D.19 Secondary Outputs Dialog Box
Note: Extra outputs that are added to a transport stream will always follow the
main output, but these secondary outputs are not shown as part of the route
view in the Equipment Status GUI.
D.9 Use of the Scrambling Control Group ID
D.9.1 Overview
This chapter describes the functionality and usage of the SCG ID setting in
nCompass Control. This document applies to all versions of MX8400 Multiplexer
and nCompass Control.
D.9.2 Description of SCG ID
SCG is an abbreviation for Scrambling Control Group. A Scrambling Control Group
is a group of components which are to be scrambled with the same Control Word,
i.e. with the same ECM. SCG ID is used as a link between the components that are
to be scrambled and the ECMs with which it should be descrambled. The SCG ID is
unique, whereas there can be many components and ECMs linked to the same
SCG ID.
2/1553-FGC 101 1014 Uen B
D-31