User guide

Setting up the SFN Functionality
Caution!
The GPS Interface Card can only be fitted in Slot 6. The card will not work in any
other slot and raises an alarm.
Figure H.3 MX8400 Multiplexer nCC Equipment Set up Screen
H.3.2 SFN Parameters
SFN parameters are defined for each country. They are entered via the nCC. In
nCompass, Profile Manager, right click on the required Transport Stream to
display the Transport Stream Tabbed Dialog Box.
An example is shown in Figure H.4. Once the parameters are entered, nCC
calculates the output bit rate. The Multiplexer uses the modulation parameters to
configure itself to the correct output bit rate.
2/1553-FGC 101 1014 Uen B
H-6