User guide

Installing and Powering Up
Installation should be in accordance with the following instructions and should only
use installation accessories recommended by the manufacturer. When rack
mounted, this equipment must have shelf supports as well as being fixed at the front
panel.
2.3.3 Lifting
The MX8400 Multiplexer may be awkward to lift. Do not attempt to lift or move it
without proper assistance or equipment. If in doubt, seek assistance.
2.3.4 Fixing
• The MX8400 Multiplexer can be installed in a 19-inch rack.
• Slide the product onto the chassis supports and affix to the rack by means of an
M6 x 18 mm panhead screw in each corner.
• Ensure that the equipment is firmly and safely located and has an adequate
through-flow of air.
• The equipment must be installed and operated in the normal horizontal
orientation, i.e. not inverted or standing on one side.
• The MX8400 must be stationary during operation.
• The MX8400 must not be used as a support for any other equipment.
2.3.5 Cable Routing
Power supply cables should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them. Pay particular attention to cables at
plugs, convenience receptacles, and the point where they exit from the appliance.
Do not run AC power cables in the same duct as signal leads.
2.3.6 Equipment Access
Ensure that the MX8400 Multiplexer is installed to allow access to the rear of the
equipment and access to the connectors.
2/1553-FGC 101 1014 Uen B
2-7