User guide

Installing and Powering Up
2.5 Connecting up the MX8400 Multiplexer
Warning!
Do not move or install equipment when still attached to the AC supply.
Caution!
Ensure ESD precautions are observed when inter-connecting equipments.
When the equipment has been installed in its intended operating position it is ready
to be connected to the rest of the system equipment. There are two sets of
connections to be made: internal and external.
All connections to external equipment are described in more detail in the following
paragraphs. Pin-out details for these connections start at Section 2.7.
2.6 AC Supply Operating Voltage, Fusing and Earthing
2.6.1 AC Supply
Warning!
Do not overload wall outlets and extension cords as this can result in a risk of fire or
electric shock.
Caution!
This product should be operated only from the type of power source indicated on the
marking label. If you are not sure of the type of power supply to your business,
consult a qualified electrical engineer or your local power company.
The equipment operates from a wide-ranging AC supply input, accepting voltages in
the range 100 – 240 V AC at 50/60 Hz nominal. Refer to Annex B, Technical
Specification for a full power supply specification.
There are no links or switches that need to be altered when operation is made from
different AC supplies. The full Technical Specification is given in Annex B at the
back of this guide.
2/1553-FGC 101 1014 Uen B
2-10