User guide

Installing and Powering Up
Ident Legend Connector
Type
Indicators Refer to
…
15 1
16
ASI IN
2
BNC
In Active Profile Off - Not in use; Green – Locked;
Yellow: Unlocked/errors
Not in active profile Off - Not in use; Flashing Green
- Link and transport stream lock; Flashing Red - No
link lock or no transport stream lock
Page 2-19
17 RELAY
9-pin D
type
—
Page 2-27
18 RS-232
9-pin D
type
—
Page 2-29
19 HSYNC IN 1
20 HSYNC IN 2
BNC Off: Not configured, Green: Receiving, Red: Fail
Page 2-30
21 SFP 2
22 SFP 1
SFP —
2.8 Ethernet Data 1 – 4 Ports
2.8.1 Overview
2.8.1.1 Port Configurations
There are four dedicated IP/GbE interface ports using RJ-45
connectors. Using nCompass Control, the MX8400 IP/GbE interface
ports can be configured as detailed in Table 2.3.
Notes: All ports support IP management data (e.g. Ping/ARP) independent of their
data path configuration.
Two Small Form Pluggable (SFP) connectors can be supplied to substitute
for Ethernet Data ports 1 and 2. When these are used, Ethernet Data ports
1 and 2 are disabled.
Table 2.3 MX8400 IP/GbE Interface Port Configurations
-1---------8-
IP/GbE Port Configuration 1 Configuration 2 Configuration 3
1 Full Duplex Input Output
2 Full Duplex Input Output
3 Disabled Output Input
Ethernet
4 Disabled Output Input
2/1553-FGC 101 1014 Uen B
2-17