User guide

Operating the Multiplexer using nCompass Control
2/1553-FGC 101 1014 Uen B
4-2
4.8.1 Overview ............................................................................................ 4-14
4.8.2 Setting up the Monitoring ................................................................... 4-14
4.8.2.1 Procedure Summary .......................................................................... 4-14
4.8.2.2 Setting up a Secondary Output .......................................................... 4-14
4.8.2.3 Set up a Secondary Output for the Transport Stream........................ 4-15
4.9 Set up PSI/SI Remultiplexing ............................................................. 4-15
4.9.1 Overview ............................................................................................ 4-15
4.9.2 Deselect the PSI/SI ............................................................................ 4-16
4.9.3 Adding the Private Data Stream......................................................... 4-16
4.10 Set up Single Program Clock Reference (Remultiplexed Input) ........ 4-17
4.10.1 Incoming Transport Stream................................................................ 4-17
4.10.2 Mixed PCR System ............................................................................ 4-17
4.11 Clone a TS in the Clear...................................................................... 4-17
List of Figures
Figure 4.1 Multiple Output Transport Stream Example........................................ 4-12
Figure 4.2 IP Properties Page ............................................................................. 4-13
Figure 4.3 ASI Monitoring for each Multiplexer Output Transport Stream........... 4-14
Figure 4.4 PSI/SI Remultiplexing......................................................................... 4-15
Figure 4.5 Clone a TS in the Clear ...................................................................... 4-17
List of Tables
Table 4.1 Local 1 Connector.................................................................................. 4-3
Table 4.2 Setting the IP Address ........................................................................... 4-3
Table 4.3 Setting the Netmask .............................................................................. 4-4
Table 4.4 Suggested Bit rates for Various Programme Types (Mbps) .................. 4-9
Table 4.5 Typical Bit rate Allocations..................................................................... 4-9
Table 4.6 Example of Weighting Factor Allocation ................................................ 4-9
Table 4.7 Bit rate Requirements Relative to Video Resolution............................ 4-10
Table 4.8 Example of Protected Channels .......................................................... 4-11
Table 4.9 Add IP Outputs on the Physical Map ................................................... 4-12
Table 4.10 Add ASI Outputs on the Physical Map............................................... 4-13
Table 4.11 Setting Up a Secondary Output ......................................................... 4-14
Table 4.12 Setting Up a Multiplexer Secondary Output....................................... 4-15
Table 4.13 Setting Up PSI/SI Remux (Selecting the PSI/SI Tables) ................... 4-16
Table 4.14 Setting Up PSI/SI Remultiplexing (Adding the Private Data Stream) 4-16