Installation manual

630077_5 Outer Skin Kit Installation Manual.doc

10.1 Installing the Flue Terminal NZ ONLY

Cut the flue termination to the height specified on the attached “Flue

position” diagrams and leave a vertical offset of 20 - 30mm between

the inner and outer as shown. Slide the flue liner sleeve over the

liner and push it down about 150mm out of the way. Fit the flue

spacer bracket between the flue and flue liner.

Cut & bend an 80mm by 100mm flap and bend

towards the inner flue as shown below.

Fit cowl and drill trough the flap, flue and

cowl stem. Using approximately a 1"

stainless steel self tapping screw fix the

cowl in place.

Slide the liner sleeve piece up under the cowl until it hits the flue spacer

bracket. Around the bottom of the sleeve drill and rivet in three places.