Installation manual

630077_5 Outer Skin Kit Installation Manual.doc
2
Note:
THERE ARE TWO MAIN THINGS TO CONSIDER BEFORE INSTALLATION
• You will need to get 230/240 Volt power supply to the back right corner of the cavity
• You will need to get gas pipe to one of the three corners of the cavity by removing a
knock out
Install gas lines to
any of these 3 points.
Leave enough piping
to reach the front
right hand corner of
the OSK once
installed.
Electrical
point of
entry.
Final gas connection point
(after OSK installation)
Plan view from top looking down.
Gas pipe