Installation manual

630077_5 Outer Skin Kit Installation Manual.doc
23
16.0 Securing the Flue Sleeve NZ ONLY:
Tighten the flue sleeve with a screw
driver and spanner, ensure a tight and
secure seal has been made between the
flue assembly and the flue outlet spigot.
16.1 Inserting the OSK Lid:
Once the previous steps have been
completed you slide the 180mm flue
sleeve (NZ ONLY) down until it rests on
the lid of the Outer Skin Kit, this will
prevent anything touching the inner flue.
The final step is to attach the front lid to
the OSK. This is attached by sliding the
lid along the top of the OSK until it
locates into the rear lid. Two screws can
now be inserted into the side panels to
hold it in place.