Installation manual

630077_5 Outer Skin Kit Installation Manual.doc

8.0 Power Supply:

The electrical cord (either of the fire, or an extension cord) should pass through the ‘Outer

Skin Kit’ as shown, through the supplied ‘Cord Strain Relief Bush’.

Locating the power outlet within the cavity makes the installation very neat but the provision

MUST be made to be able to switch the power supply off and on (electrical isolation switch)

and MUST be accessible after the heater has been installed. This is normally done by

means of a separate switch located outside of the cavity and wired to the plug. This will

allow service technicians to isolate the power supply before performing service work on the

appliance.

8.1 This appliance will draw a maximum of 1.2 Amps from a 240V supply.

No additional power telephone wiring is needed for the i-con phone switch (optional extra in

New Zealand only).