Full Product Manual

2.4G RF Dim & CCT Selectable LED Panel (Can be set
lights as standard lighting with default 4000K)
Recessed Mount
Ceiling
Ceiling
Ceiling Ceiling
Ceiling Ceiling
1. Ensure the panel light work well before installation, put the panel light at a diagonal position.
2. Put the driver aside and insert panel light into ceiling.
3. Rotate the panel light 45° in horizontal direction to make the front of panel face to ceiling square hole.
4. Rotate the panel light 90° in vertical direction to make it correspond to the recessed frame and
front of panel face to ground.
5. Embed the panel light into ceiling, adjust it to a suitable position to make it as flat as ceiling.
2.4G RF Dim & CCT Selectable LED Panel (Can be set
lights as standard lighting with default 4000K)
Suspension Mount
x 2
x 2
-1000mm
x 2
600
400-1000mm
1. Make sure that the ceiling can hold the weight of the LED panel and install ceiling brackets
suitable to support the weight of the LED panel.Fixing cables.
2. Gather panel and connect the wires as shown in”Assembling panel”
3. Attach the suspended cables to the bends at the edges of the LED flat panel.
4. Turn on the main power. installation is finished.
2.4G RF Dim & CCT Selectable LED Panel (Can be set
lights as standard lighting with default 4000K)
Surface Mount
1. Parts A1,A2, B1,B2;
2. First install A1, A2, and B1(as illustrated);
3. As is shown in the figure,fix A1 and A2 on the ceiling or on the roof,and then insert the panel light directly
(the end with power source enters later);
4. Install B2, finish installation.
L out
EE Systems Group Inc. www.eleding.com , [e-mail]. 1-877-579-3889 (M-F, 10am-5pm PST), v062019
EE Systems Group Inc. www.eleding.com , [e-mail]. 1-877-579-3889 (M-F, 10am-5pm PST), v062019
EE Systems Group Inc. www.eleding.com , [e-mail]. 1-877-579-3889 (M-F, 10am-5pm PST), v062019