Specifications

INSTALLATION INSTRUCTIONS

Remove Mounting Plate

NOTE: To avoid possible damage to the work surface, cover the

work surface.

1. Remove any remaining contents from the microwave oven

cavity.

2. Remove the mounting plate by peeling off the strips of tape

that attach it to the back of the microwave oven, and set the

mounting plate aside.

3. Tape the microwave oven door closed so that door does not

swing open while the microwave oven is being handled.

NOTE: Do not grip or use the door or door handle while the

microwave oven is being handled.

Rotate Blower Motor

The microwave oven is set for recirculation installation. For wall or

roof venting, changes must be made to the venting system.

NOTE: Skip this section if you are using recirculation installation.

Keep the damper assembly in case the venting method is

changed, or the microwave oven is reinstalled in another location

where wall or roof venting may be used.

Wall Venting Installation Only

1. Remove screws attaching damper plate to top of microwave

oven exterior. Slide damper plate toward the front of the

microwave oven and lift up.

2. Keep damper plate and screws together and set aside.

3. Remove 2 screws attaching blower motor to back of

microwave oven.

4. Lift blower motor out of microwave oven.

A. Mounting plate

B. Back of microwave oven

C. Tape (multiple locations)

A B C

AScrews

B. Damper plate

A. Screws (in recessed holes)

A. Blower motor