User Manual

User Manual 9
Install Source 4 WRD retrofit
1: Use oil-free canned air to clean the LED domes prior to installation.
2: With the fixture resting securely on a flat surface, attach the supplied
threaded post to the back end of the fixture body. Use a crescent
wrench to tighten the threaded post one-quarter turn past finger tight.
3: Gently slide the Source 4
WRD LED onto the fixture body and threaded
post while guiding the LED tower into the lamp housing hole, as shown
below. Take care to prevent contact between the LEDs and the
reflector.
4: Use a #2 Phillips screwdriver to tighten the screw located on the back
end of the Source 4
WRD LED, directly above the Z-adjustment knob.
5: Pull gently to verify secure attachment.
WARNING:
RISK OF FIRE OR ELECTRIC SHOCK: Install this kit only
onto luminaires that have the construction features and
dimensions shown in the images in this document and
where the input rating of the retrofit kit does not exceed
the input rating of the luminaire.
WARNING:
Do not make or alter any open holes in an enclosure of
wiring or electrical components during kit installation.
CAUTION:
Do not touch or clean LED optic domes with anything
other than oil-free canned air.
Insert threaded
post here
Tighten
screw
Z-adjustment
knob
Source Four
fixture body
Lamp housing
hole