User Manual

ETC Configuration Guide
Paradigm Serial Access Protocol (PSAP)
PSAP Configuration Guide Page 5 of 7 Electronic Theatre Controls, Inc.
Macro Commands
Override Commands
Log Commands
The following commands allow the serial device to temporarily alter logging setup.
Received Data Resulting Action
macro on macroname Executes On steps of a macro
macro off macroname Executes Off steps of a macro
macro tog macroname Toggles macro state
macro cancel macroname Cancels execution
macro on Macro 1 executes on steps of Macro 1
Received Data Resulting Action
ovr enab overridename Enables override
ovr disab overridename Disables override
ovr tog overridename Toggles override state
ovr enab Override 1 enables Override 1
Note:
The property set for “Verbose Logging” property in LightDesigner will be restored as
the logging setup after any Paradigm Architectural Control Processor (P-ACP) reboot.
Received Data Resulting Action
log disabled Disables logging
log ascii sets log format to ASCII
log dec sets log format to decimal
log hex sets log format to hexadecimal
log get retrieves the current log setting