Installation Guide

5 WWW.ETISSL.COM
Please contact 1-855-384-7754 for further assistance.
Installation
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the
circuit breaker before removing the existing light fixture or installing the new one.
With the power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire
color) or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
Downrod Mounting
1
Attaching the yoke to the fixture
□ Attach the yoke mounting bracket (AA) to the fixture
body (A), using the silicone washers (BB) and the hex
bolts (CC).
2
Attaching the downrod to the yoke
mounting bracket
□ Place the 1/2 in. rigid pipe downrod (II) (not included)
through the center hole in the yokemounting bracket (AA).
□ Secure it with the flat washer (JJ) and two hex nuts (KK)
(not included).
II
A
BB
CC
AA
JJ
KK
AA
A