Installation Guide

9 WWW.ETISSL.COM
Please contact 1-855-384-7754 for further assistance.
Yoke Mounting (continued)
2
Attaching the yoke to the fixture
□ Attach the yoke mounting bracket (AA) to the
fixture body (A), using the silicone washers (BB)
and the hex bolts (CC).
3
Making the electrical connections
□ Run the power cable and dimming cable from the fixture body (A) to
the electrical outlet box, feeding the wires through the two waterproof
connectors (FF).
□ Insert the waterproof connectors (FF) into the electrical outlet box.
□ Connect the hot and neutral (black and white) wires from the fixture
body (A) to the same color wires in the electrical box.
□ Connect the green wire from the fixture body (A) to the ground wire in the
electrical box.
□ If a 0-10v dimming circuit is available, connect the purple and gray wires
from the fixture body (A) to the same color wires in the electrical box.
□ If 0-10v dimming is not desired, wrap the ends of the purple and gray wires
with electrical tape to cover the wire.
□ Cover the wire connections using the wire connectors (GG).
□ Wrap the wire connectors (GG) with electrical tape for a more secure
connection.
□ Tuck all electrical connections into the electrical outlet box.
4
Completing the installation
□ Cover the electrical outlet box.
□ Restore power at the electrical panel.
□ Turn on the light switch to activate the fixture.
A
BB
CC
AA
FF
GG