Installation Guide

6 7 WWW.ETISSL.COM
Please contact 1-855-384-7754 for further assistance.
CC
Hook Mounting (continued)
3
Attaching the yoke to the fixture
□ Hook high bay fixture to eyelet or chain (provided by
others). Lock the captive screw (DD).
AA
4
Making the electrical connections
□ Connect the incoming electrical wires to the set of power
wires black to black (hot), white to white (neutral) and
green to green (ground).
Conduit Mounting
1
Attaching the yoke to the conduit
□ Attach conduit to yoke (CC) and secure with locking
washers (provide by others).
2
Making the electrical connections
□ Connect the incoming electrical wires to the set of power
wires black to black (hot), white to white (neutral) and
green to green (ground).
DD
BB
CC
7
Motion Sensor Installation
1
Locking the junction box
□ Align the end of the junction box (EE) with the two
holes on the fixture, using the screw driver, firmly
tighten the screws (GG) to the fixture.
2
Installing the motion sensor
□ Make sure the bolt screw is inserted into the round
opening of the junction box (EE). Use the screw nut (HH)
to firmly secure the bolt screw to the junction box case.
Position the motion sensor (FF) induction head such that it
faces down toward the floor and that it is horizontally flush
with the side of the junction box (EE).
3
Clipping the input wire and stripping the wire sheath
□ Use the cutter nips to cut the input wire on the A1 location ( Be careful the length of B wire retain about 7.87 inch ), then use
the wire stripper to shuck the plastic insulation of both wires ( Be careful not to peel wire core ) to expose the bare wire of the
cable.
AC Line
CAUTION: Need to clip the input wire when install the
motion sensor.
AC Line