Operation Manual

17 MAINTENANCE
Changing the direction in which
the door opens
1. Adjust the two levelling feet to their highest
position. Tilt the refrigerator backwards
and rest it on something solid.
Attention: Do not lay the refrigerator
completely flat as this may damage the
coolant system.
2. Undo the 3 screws and remove the lower
hinge.
3. Slide the door down about 15 cm until it
comes loose from the upper hinge and
remove the door.
4. Remove the blanking plates covering the
handle screws. Remove the screws and
then remove the handle.
5. Remove the blanking plates from the
opposite side of the door.
6. Fit the handle to the other side of the door
with the 2 screws. Replace all the blanking
plates.
7. Using a flat bladed screw driver remove
the pin from the top hinge. Replace it in the
hinge on the opposite side.
8. Remove the screw from the side of the
refigerator where the hinge is to be re-
fitted and replace it on the other side.
9. Slide the door back on to the top hinge,
making sure that the upper hinge pin fits
into the upper hole of the door.
10.Fit the lower hinge to the other side of the
refrigerator.
11.Check that door is aligned horizontally and
vertically and that the seals are closed on
all sides before finally tightening the
bottom hinge. Level the appliance with the
adjustable feet.
88026124 HL EVV.qxp 14-03-2008 17:09 Pagina 17