Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Return the arms to suitable position, see figure.1.
2. Attach the pipe(B) and(A) to the top pipe thread of the fixture body(C), by turn
it clockwise until tight.
3.
Install the light bulbs(not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
HANGING THE FIXTURE (Fig.2)
1. Shut off the power at the circuit breaker and remove old fixture from ceiling,
including the old single bar. Carefully unpack new fixture and lay all the parts
on a clear surface.
2. Attach the mounting screw part way into the side hole of the single bar, then
lock it securely with hex nut until becoming. Attach the single bar to the
junction box using two box screws as shown. The side of the single bar
marked “GND” must face out.
3. Using proper chain pliers to open one end link of the chain provided and
connect to the fixture loop. Close the link.
4. By measuring, determine correct number of links needed for proper hanging
height. Using proper chain pliers disconnect and discard remaining chain.
5. Lace the fixture wires through the chain.
6. Open the other end link of the chain and hang the fixture on the loop at the
ceiling. Close the link.
7. Feed the fixture wires through the loop of the canopy and pull until taut.
8. Slide canopy up flush to ceiling, lock it securely with ball nut.
CONNECTING THE WIRES (Fig.3)
1. Take the black wire from the ceiling junction box and the smooth wire leg from
the fixture and twist bare ends together. Twist wire connector onto end of wire
until snug.
2. Repeat same process with white junction box wire and ribbed wire leg of
fixture wire. NOTE: Twist wires together in the same direction you twist the
wire connector onto wires.
3. If your junction box has a grounding wire (green or bare copper), attach this
wire and the bare copper wire from the fixture together as step 1.If junction
box has no ground wire, attach the bare copper fixture wire to the green
ground screw on the single bar.
4. Tuck these wire connections neatly into the ceiling outlet box and then raise
the canopy all the way to the ceiling, lock it securely with ball nuts.
Your installation is now complete. Return power to the junction box and test
the fixture.
A
B
C
singlebar
Screw
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
©COPYRIGHT ALL RIGHTS RESERVED.
FIG.3
FIG.1
FIG.2
Thank you for purchasing our product.
Need assistance with parts or assembly? Please call customer service