Owner Manual

F4707Q110V/F4707BK110V
Installation & Operating Instructions for the
Parrotuncle Owner's Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Table of Contents
1. Fan / Remote is not working
2. Fan is noisy
3. Fan Wobbles
4. Light is not working
Please refer to the instruction sheet for detailed directions and descriptions of
installation steps
and requirements.
1. FAN / REMOTE IS NOT WORKING
Ensure the remote is within the 20 foot range of the receiver
To reset the remote control: 1) Turn off power to fan using the wall switch or circuit breaker. 2) Remove ba eries from remote.
3) Wait 10 seconds. 4) Replace ba
eries and turn power on
Check ba eries to insure they are good and oriented correctly
Check to make sure the frequency switches (DIP Switches) from the remote to the receiver are set to the same frequency
Check the main and branch circuit fuses or breakers
If using a Variable Speed Wall Switch, ensure it is specifically designed for use with a ceiling fan.
Check the line wire connec ns to the fan and the switch wire conn e switch housing per the instru ns
[e-mail]
2. THE FAN IS NOISY
Make sure all motor housing screws are tened
Make sure the screws that a an blade to motor ar t
Make sure the wire nut connectors are not ra against each other or the interior wall of the switch housing
Allow 24-hour break in period. Most noises associated with the new fan may disappear during th me
If using a ceiling light kit, make sure the glassware is secur htly
Make sure there is a short distance/gap from the ceiling to the top of the canopy. The canopy should not touch the ceiling!
Make sure your ceiling box is secure and that the rubber isolator pads are used between the moun acket and outlet box
TROUBLESHOOTING GUIDE