Operation Manual

GB
20
Refilling of rinse aid
The rinse aid, which is released automatically
during the final phase of the wash cycle,
guarantees that the dishes dry quickly and
prevents the formation of stains and calcium
sediments.
The rinse aid container S is located on the inside
of the door.
• Fig. 8, remove the container cap T by turning it
1/4 revolution anticlockwise.
•
Fig. 9, open cover T1.
- Fill container with rinse aid up to the broken
line.
Maximum quantity: about 140 ml.
- Close the rinse aid compartment again.
- Clean off possible residues of rinse aid with a
cloth, otherwise too much foam might be pro-
duced during the rinsing process.
Indication of rinse aid level
• Electric (if included) (fig. 18-18.a)
The appliance is equipped with a level indicator
for the rinse aid. When it lights up, more rinse
aid needs to be added.
• Mechanical (fig. 8)
More rinse aid needs to be added when the
indicator (located on the container F) is clear
(
).
When the container is full, the indicator has a
dark coloration.
Regulation of the water softener system (IF INCLUDED)
(control panel version with display)
To reach an optimal regeneration setting, keep the button DELAY (fig. 7) pressed when turning on
the appliance. Now, the current setting is being displayed (e.g., d4). To modify the setting (within 6
seconds), press the same button again until the desired level is reached (see table).
Wait for 6 seconds without modifying the setting. A buzzer sound will indicate that the new setting was
accepted. On the display, the request select programme will appear.
7
S
T
1
8
S
F
T
‘Hidden’ control panel
‘Exposed’ control panel
Note: The salt level indicator on the
Display is deactivated when position D1
is used.
D
D
Only use rinse aids for
dishwashers. Other products
won’t obtain the desired effect.
D
d1
d2
d3
d4
<15
>15 <25
>25 <40
>40 <60
>= higher / <=lower
<8,4
>8,4 <14
>14 <22,4
>22,4 <33,6
d5
>60
>33,6
French
degrees
German
degrees
Regeneration
levels