User Manual

Pairing will create a link or connection between the two Bluetooth devices,

the SuperTooth II and your phone.

1. Bring the mobile phone at about 20cm from the SuperTooth II.

2. The SuperTooth II is initially off; Turn it on by flipping

up the Swivel Arm[1] to 55º position. The Bluetooth

Indicator[8] will glow (blue blink).

3. Simultaneously press the Reject Button[2] and

Accept/End Button[6] for about 5 seconds. A

distinctive tone will be heard and the Bluetooth

Indicator LED will change from blinking blue to

alternate blinking red and blue. The SuperTooth II

is now in Pairing Mode.

4. While the kit is at pairing mode, access the Bluetooth menu of your

phone. (Kindly refer to your phone’s manual.) Turn on its Bluetooth

function then execute a Bluetooth search so that it will be able to search

and find your SuperTooth II.

5. When the phone displays the list of the Bluetooth devices it found,

select the name of this kit (SuperTooth II).

6. When the phone asks for the passcode, enter 0000. Pairing is

successful if the alternating red/blue lights of Bluetooth Indicator

changes to plain blinking blue. Note : Normally, the phone would also

show briefly on its display if it’s already paired and connected to

the SuperTooth II or if pairing with it failed.

Important Note: Some phones do not connect directly after entering

0000. To connect, you need to short press the Accept / End Button[6].

Or,

(In your phone) Go back to Bluetooth> Paired devices> highlight the

name of this kit (SuperTooth II) > press Options > then press

Connect).

If pairing has been successful, the SuperTooth II is now ready to use.

E. PAIRING TO A MOBILE PHONE (not possible while charging the SuperTooth II)