User Manual

Supertooth II

OPERATIONS

Make a Call (Normal dial): Dial the number using your phone. Normally,

audio will be on the kit.

Note: With some phones like Siemens S55; Panasonic X70, audio is

always on the phone during an outgoing call. You will need to short

press Accept / End Button[6] to transfer the audio to your kit.

Make a Call (Voice dial):

1. First, you have to access the voice dialing function of your phone,

turn it on and record for a voice tag. (Kindly refer to the procedure

in your phone’s manual.) Note: Voice dialing entries must be

stored in the phone’s memory, not on the SIM card!

When done, execute voice dialing in your kit by proceeding with the

instructions.

2. Execute Voice dial: Short press Accept/ End Button[6].

3. A beep/short tone will then be heard on the SuperTooth II prompting

the user to say a voice tag of a contact to call.

4. Say the voice tag. The voice will be played back to you (audio on

kit) then the phone will dial the number automatically.

End a Call (only 1 procedure for Headset Profile):

Short press the Accept/ End Button[6].

Answer a Call: When the phone receives a call, ring tone will be on the

SuperTooth II alone, or both on the SuperTooth II and on the phone

(depending on your phone model). Just short press Accept/ End

Button[6] to answer the call.

Set the Volume: Set the volume using the Volume Control[10].

1. Turn it clockwise to increase the volume.

2. Turn it counterclockwise to decrease.

Note: If the volume set is too high, it can cause feedback (whistling

sound), echo, or background noise during calls on some cell phones.

I. HEADSET PROFILE