User Manual

7
Audio Transfer :
from Phone to SuperTooth II (SuperTooth II initiated):
Short press the Accept/ End Button[6].
Accept / End
Button
(Short press)
Accept / End
Button
(Long press)
Reject Button
(Short press)
Reject Button
(Long press)
Connected / Standby Initiates voice dial
Disconnected /
Standby
Creates
reconnection
and initiates
voice dial
Incoming call (ring
being generated)
Accepts the call
Active call at
SuperTooth II
Ends the call
Active call at Phone
Transfers the call
to SuperTooth II
Outgoing call being
set-up
Ends the call
J. Button Functions Matrix (Headset Profile)
FCC Notices
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference
that may
cause undesired operation.
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
FCC RF Exposure requirements:
“This device and its antenna(s) must not be co-
located or operating in conjunction with
any other antenna or transmitter.”