Instruction manual

4
1
Attention:
Turn power switch to "O" before carrying out any of the operations
below.
Raise the needle to its highest position and raise the presser foot
lever. Attach the presser foot holder (b) to the presser foot bar (a). (1)
Lower the presser foot holder (b) until the cut-out (c) is directly above
the pin (d). (2)
Raise the lever (e).
Lower the presser foot holder (b) and the presser foot (f) will engage
automatically.
Raise the presser foot.
Release the pressure foot by raising lever (e) located at the back of
the foot holder. (3)
Attach the seam guide (g) in the slot as illustrated. Adjust the
distance as required for hems, pleats, etc.... (4)
Attaching the presser foot:
Removing the presser foot:
Attaching the seam guide:
Attaching the presser foot holder
10
a
b
g
2
e
a
e
b
d
c
f
3
e