OWNER’S MANUAL Craft Iron Model IR410 For information or assistance: EURO-PRO Operating LLC 21 Lawrence Paquette Industrial Drive. Champlain, NY 12919 www.euro-pro.
IMPORTANT SAFETY INSTRUCTIONS When using your iron, basic safety precautions should always be followed, including the following: 1. Read all instructions carefully. 2. Use iron only for its intended use. 3. To protect against risk of electrical shock, do not immerse the iron in water or other liquids. Always turn the iron to “OFF” before plugging in or unplugging from outlet. 4. Never yank cord to disconnect from outlet. Grasp plug and pull to disconnect. 5. Do not allow cord to touch hot surfaces.
TROUBLESHOOTING PROBLEM Iron does not heat Thermostat ready light goes On and Off POSSIBLE REASONS & SOLUTIONS • Iron should be plugged into a 120V AC electrical outlet only. Make sure that the plug is securely in the socket. • Temperature setting too low. Turn to higher setting. • This is normal. The light goes On and Off as the thermostat is switching the heating element On and Off to maintain the selected temperature. Some odor or small particles come out of steam vents of new iron • This is normal.
GETTING TO KNOW YOUR IRON Before using your Craft Iron, remove any labels, stickers or tags that may be attached to the body or soleplate of the iron. When turned on for the first time, your new iron may emit an odor for up to 10 minutes. This is due to the initial heating of the materials used in making the iron. 5 The odor is safe and should not reoccur after initial heating.
OPERATING INSTRUCTIONS USER MAINTENANCE INSTRUCTIONS STORAGE EMPTYING THE IRON 1. Always turn the variable steam control to “0” after you have emptied the water tank. 1. Always empty iron after each use. 2. When finished using the iron, turn the variable steam control to “0” and the temperature control dial to “MIN”. 2. Allow the iron to cool down. 3. Always store the iron in the upright position to protect the soleplate. 3. Unplug the iron from the electrical outlet. 4.
OPERATING INSTRUCTIONS (CONT.) 4. Turn the temperature dial to any of the temperatures within the gray steam band and allow the iron to heat for approximately 2 minutes before ironing. Place iron on its heel (on a stable, protected surface) while the iron is warming to desired temperature. OPERATING INSTRUCTIONS (CONT.) 2. Set the temperature dial. Place the iron on the stand (on a stable, protected surface) and allow it to heat for approximately 2 minutes. 3.