User`s guide

3
2) Press the recessed black button to turn
on the TT100. The power is on only as
long as the button is being pressed. The
battery low LED flashing on during turn on
and turn off is normal.
3) Adjust volume to a comfortable level.
If the signal is very loud when near
the cable, the volume may need to be
reduced to keep from overloading the
TT100. When overloaded, small increases
or decreases in the signal at the tip
cannot be heard.
4) Hold tip of TT100 near cables to be
identified. The signal will be loudest
on the wire or cable with the generator
attached to it. Separating the wires or
cables may help in identifying the correct
one.
To Use Headset
1) Insert 2.5 mm headset plug into end
of TT100 by the lanyard loop, be sure
to fully seat the plug into the jack. The
speaker is automatically disconnected.
2) Proceed as in the preceding section.