User`s guide

4
To Change the TIP
1) Remove screw nearest to the tip on
the back of the TT100 with a #1 Philips
screwdriver.
2) Pull the tip out of the front.
3) Push new tip into front.
4) Replace screw and tighten (about 4 in-
lbs), being careful not to over tighten.
Battery Replacement
When the battery low LED is on continuously
whenever the “on” button is being pressed,
replace the battery.
1) Remove screw at the back of the TT100
with a #1 Phillips screwdriver. Remove
battery door.
2) Remove old battery and disconnect from
battery leads.
3) Snap battery leads onto new battery (9
volt, alkaline). Place battery in case.
4) Replace battery door and screw. Do not
over tighten.