Operation Manual

19
 Now squeeze the trigger – the machine will start.
 Take note! Wait at least 3 seconds after releasing the trigger, before squeezing it in again. If this is
not done, the device will 'hiccup'.
 The automatic start/stop system means that the motor only works when the trigger is
squeezed!
Important: Always point the jet down!
 The jet produced by the jet lance can be adjusted from narrow to wide by turning the head of the
lance. Never do this while spraying!
 The rotating head creates a narrow rotating jet.
 The terrace cleaner is intended for the cleaning of hard,
even, flat surfaces such as terraces, small streets, steps,
(garden) walls, etc. The cap provides protection from water
splashing back. Attention: the powerful jets can damage
softer materials such as paint and wood, etc. (see for
assembly terrace cleaner fig. 13 too)
TIPS FOR USE
 When the water jet leaves the nozzle it causes the handle to recoil. You must therefore ensure that
you are standing in a stable position and have a firm grip. Also ensure that the high pressure of the
water jet does not cause objects to move out of place or fall or fly around and cause damage. Also
select a safe location for yourself!
 Keep your work environment clean and tidy.
 The high-pressure jet can cause damage to, for example, tyres if you move the jet too close. Always
maintain a minimum distance of 30 cm from the object to be cleaned! Always adjust the distance to
the object to be cleaned (and therefore the pressure) appropriately.
 Work from the bottom to the top in the case of vertical surfaces.
 Prevent water from splashing onto undesired places.
 Do not move the cleaner by pulling the electrical cable. Do not lift the machine up with the cable.
Prevent damage to the cable caused by oil, solvents, sharp edges, etc. Do not cover the machine
during use.
 Do not use the machine in an insufficiently ventilated room.
 It is forbidden to clean surfaces containing asbestos with high-pressure.
 If the machine is not used for longer than 5 minutes it must be switched off.
SWITCHING OFF
 Switch the machine off (Button to 0 - OFF).
 Close the water supply.
 Allow any pressure to escape by squeezing the trigger until no more water comes out of the nozzle.
 Close the safety lock on the handle.
 Pull the plug out of the socket.
STORAGE
 Before clearing the machine away, the water must be removed from the pump, the hose and the
accessories. You do this by switching the machine off with the switch and disconnecting the water
supply hose. Now start the machine again and squeeze the handle. Allow the machine to operate
until no more water comes out of the jet lance. Then switch the machine off immediately. Never allow
it to ’run dry’!
 Remove the plug from the socket, wind the hose up and hang the cable on the hook.
 Place the handle and the lances in the holders on the machine.
 The machine must be stored frost-free. If this is impossible, have the machine suck in anti-freeze
before you store it. Remember to flush the machine thoroughly with water before using it again! If the
machine nevertheless freezes, have it checked before use. Frost damage is not covered by the
guarantee. Never start a frozen high-pressure cleaner!