Operation Manual

21
The fuse burns out
- The electrical installation is too light. Connect the machine to an installation that has greater Amperage
than the machine. Do not use an extension cable.
The machine vibrates
- Air in the water supply hose. Allow it to escape by running water through the machine while it is
switched off.
- Problems with the water supply. Does it meet the requirements? Do not use an excessively long or thin
hose (min. ½”).
- The nozzle is partially blocked. Clean it.
- Water inlet filter is dirty. Clean it
- There is a kink in the hose. Straighten it.
The machine regularly starts and stops by itself
- Pump or spray lance are leaking. Have them repaired or replaced.
The machine starts but does not supply water
- Pump, hose or accessories are frozen. Allow them to thaw and then check them.
- No water supply. Ensure that there is a water supply.
- Filter blocked. Clean the filter.
- Nozzle blocked. Clean the nozzle.
Please contact your dealer if there are any other problems!