Operation Manual

35
a) Place the device on a flat, level surface and start and
warm up the engine for a few minutes. Stop the engine
and turn off the fuel cock (OFF). Close the ventilator
knob on the tank cap (clockwise).
b) Loosen the screw and remove the side panel, see fig.
c) Remove the cap from the oil filter.
d) Place a collector tray under the generator and tilt it so
that all oil runs out
e) Place the generator back on the flat, level surface
f) Pour the new engine oil into the reservoir until the
maximum level is reached
g) Put the oil filter cap back on
h) Replace the cover and screw it tight
 Recommended engine oil: API Service “SJ” or above
Warning!
 Ensure that no foreign materials get into the carter.
 Do not top up oil in a generator that is not horizontal; that
could result in overfilling and damage to the engine.
 Clean the oil filter every 100 operating hours.
V-3 – Air filter
It is very important that the air filter is kept in good condition.
Pollution due to badly installed, incorrectly maintained or
wrong air filter will cause premature damage and wear to
the engine. Therefore always keep the filter clean.
a) Loosen the screw and remove the side panel.
b) Remove the cover from the air filter and the
filter.
c) Wash the filter in a mild soapy solution and
allow it to dry properly.
d) Drop a little oil on the filter and squeeze it so
that the oil spreads and excess oil runs off
(squeeze don't wring!). The filter must be moist
but not dripping.
e) Reinstall the filter.
f) Replace the cover and attach the side panel
again.
Warning! Never run the generator without air filter!
This will cause extreme wear of the piston and/or
filter.