Operation Manual

VI – SOLVING PROBLEMS

VI-1 – The engine will not start

 Fuel is not being transported to the carburettor

- The fuel tank is empty - put in fuel

- There is fuel in the tank – turn the fuel cock and the ventilation knob to ON

- The fuel line is blocked – clean it

- The carburettor is blocked – clean it

 The engine has insufficient oil

- Add oil

 Problems with the ignition system, insufficient spark

- The spark plug is dirty or damp – clean and/or dry it

- Problems with the ignition system – consult your dealer

VI-2 – The generator is not generating electricity

 The safety facility AC is set to OFF

- Stop the engine and re-start it

 The safety facility AC is set to OFF

- Press it to reset it.

VII - Storage.

If being stored for a longer period your generator requires a number of preventative

measures to protect it.

VII-1 – Drain off the fuel

a) Remove the tank cap and allow the fuel to drain from the tank

b) Remove the side panel and allow the fuel to also drain from the carburettor

VII-2 – Engine

a) Remove the spark plug and pour a teaspoon of motor oil (SAE 10W30 or 20W40) into

the opening. Reinstall the spark plug.

b) Allow the engine to turn over a few times by pulling gently on the recoil starter (without

ignition).

c) Pull the starter cord out slowly until you feel resistance.

d) Then stop pulling

e) Clean the outside of the generator and use a rust retarder

f) Store the generator in a dry, well-ventilated area and cover it.

g) The generator must stay upright.