User Guide

– 7 –
On factory default the device does not belong to
any Z-Wave network. The Door/Window Contact
Z-Wave Plus needs to be added to an existing
Z-Wave network to communicate with the devices
of this network. This process is called Inclusion.
The Door/Window Contact Z-Wave Plus can also
be removed from a Z-Wave network. This process
is called Exclusion. Both processes are initiated
by the primary controller of the Z-Wave network.
This controller is turned into exclusion respective
inclusion mode. Consult the installation and oper-
ation guide of your Z-Wave controller in order to
find out how to activate the Inclusion or Exclusion
mode of your Z-Wave controller.
If the Door/Window Contact Z-Wave Plus has
been added to a network, it has to be removed
prior to be added to another wireless network.
6. Commissioning
Interoperability
This product can be operated in any Z-Wave
network with other Z-Wave certified devices from
other manufacturers. All non-battery operated
nodes within the network will act as repeaters
regardless of vendor to increase reliability of the
network.
Security
The Door/Window Contact Z-Wave Plus supports
secure communication. The Door/Window Contact
Z-Wave Plus will communicate with other devices
secure as long as this device provides the same or
a higher level of security. Otherwise the Door/
Window Contact Z-Wave Plus will automatically
turn into a lower level of security.
Note:
A Security Enabled Z-Wave Controller must be
used to fully utilize the Door/Window Contact
Z-Wave Plus.