User Guide

– 8 –
Start the inclusion mode of your primary Z-Wave controller .
Press the button within the housing of your Door/Window Contact three times in quick succession in order to
activate the inclusion mode. While the inclusion mode is active, the green LED is blinking. The joining attempt
takes approx. 30 seconds.
If the inclusion was successful, the green LED lights up for 5 seconds. Otherwise, the red LED light up for 5
seconds to indicate failure.
Start the exclusion mode of your primary Z-Wave controller.
Press the button within the housing of your Door/Window Contact three times in quick succession in order to
activate the exclusion mode. During the attempt to leave the network, the green LED is blinking.
If the exclusion was successful, the green LED light up for 5 seconds. Otherwise, the red LED lights up for 5
seconds to indicate failure.
Note: When removing (Exclusion), the configuration of the device is kept. Only the network is exited.
6.2 Add to a Z-Wave Network (Inclusion)
6.3 Remove from a Z-Wave Network (Exclusion)
6.1 Inserting Batteries
1. Open the housing of the Door/Window Contact. .
2. Insert the battery into the housing. When inserting the battery, make sure that you insert the battery sideways
(Fig. 1).
Fig. 1